Product Information:
A Handle Clamp is an essential item to make a KingsWeld connection. Different clamps are available for different types of moulds.
Features:
Following clamps are available:
- For use on D types moulds
- For use on E & F types moulds
- Cathodic Protection
- Chain Handle/Support Clamp
- Conductor Support Clamp
- Rail Applications
More Information:
Before making a KingsWeld connection:
- Always wear proper clothing, gloves and safety glasses when exothermic welding.
- Read the general safety instructions and the positioning of conductors sheet supplied with each KingsWeld mould to familiarise yourself with the procedure you are going to perform.
- Make sure the conductors that are to be welded are dry, dirt-free and clean.
- Use the wire brush to clean the conductor surfaces being placed inside the mould – the cleaner the surface the better the connection will be.
- Attach the handle clamp to the KingsWeld mould and check it will open & close freely.
- Make sure that the KingsWeld mould is dry and moisture free. The best way to do this is by pre-heating the mould with a blow torch or by making a test connection.
